Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
Show only
|
Search instead for
Did you mean:
This page has been translated for your convenience with an automatic translation service. This is not an official translation and may contain errors and inaccurate translations. Autodesk does not warrant, either expressly or implied, the accuracy, reliability or completeness of the information translated by the machine translation service and will not be liable for damages or losses caused by the trust placed in the translation service.Translate
I've been using AutoSketch 7 (build 54) on and off for years without problem. The last time I tried to run the program I got an error message box "Sketch.exe - Entry Point Not Found" stating "The procedure entry point ?ucsorg@AcDbDatabase@@QBE?AVAcGePoint3d@@XZ could not be located in the dynamic link library ACDB15.dll. " I removed AutoSketch and re-installed it but still get the same problem. I'm running W2k SP4. Any suggestions?
I tried the W2k Remove Program again. This time I noticed that it did not remove the files in
C:\Program Files\Common Files\Autodesk Shared
so I manually eliminated them. I then rebooted and did a fresh install of AutoSketch and loaded the update to SX2.DLL. This time everything worked. So now I'm happy but still a little puzzled as to the cause of the problem in the first place.
![Autodesk Design & Make Report](https://forums.autodesk.com/t5/image/serverpage/image-id/1350519iCB55845EBFC43016/image-size/large?v=v2&px=999" "Autodesk Design & Make Report")