I have Auto Cad 2013 LT for mac and I was trying to figure out how to batch publish in project manager to arch D. I have no issue individually exporting to PDF but I would like to use project manager if I could figure it out. There seems to be very little recoursces out there for it though. If anyone could provide help, it would be greatly appriciated.
Bellow is the code that was errored when trying to batch publish.
///////////////////
Job: - Error(s) Did Not Plot
Job ID: 2
Sheet set name: Teradyne
Date and time started: 7/20/12 Friday, July 20, 2012 2:37:04 PM Eastern Daylight Time
Date and time completed: 7/20/12 Friday, July 20, 2012 2:37:04 PM Eastern Daylight Time
UserID:
Profile ID: <<Unnamed Profile>>
Total sheets: 1
Sheets plotted: 0
Number of errors: 3
Number of warnings: 0

Sheet: PV Layout - Error(s) Did Not Plot
File: /Users/absolutehaitian/Documents/Absolute Green/Teradyne/Teradyne-PV100-ProjectCoverPage.dwg
Category name:
Page setup:
Device name:
Plot file path:
Paper size:
ERROR: The PMP folder was not found and is required for custom paper size creation.
ERROR: Internal error attempting to create custom paper size.
ERROR: Unable to create the requested media size as a custom size.
Job: - Error(s) Did Not Plot
Job ID: 1
Sheet set name: Teradyne
Date and time started: 7/20/12 Friday, July 20, 2012 2:33:59 PM Eastern Daylight Time
Date and time completed: 7/20/12 Friday, July 20, 2012 2:34:00 PM Eastern Daylight Time
UserID:
Profile ID: <<Unnamed Profile>>
Total sheets: 1
Sheets plotted: 0
Number of errors: 3
Number of warnings: 0

Sheet: PV Layout - Error(s) Did Not Plot
File: /Users/absolutehaitian/Documents/Absolute Green/Teradyne/Teradyne-PV100-ProjectCoverPage.dwg
Category name:
Page setup:
Device name:
Plot file path:
Paper size:
ERROR: The PMP folder was not found and is required for custom paper size creation.
ERROR: Internal error attempting to create custom paper size.
ERROR: Unable to create the requested media size as a custom size.