I am building a model in ASD consisting of HSS tubes and plates. I have been able to cap the ends of the HSS with plates using the UCS and plate command in the modeling ribbon.
How do I accurately insert a hole in a plate? I want to put the center of a 0.563" diameter hole exactly 0.75" inside two edges of a 4.25" x 2" x 3/8" plate. My snaps only appear to attach to the work frame not the plate. Apparently, I can't even snap a line off the corners of the plate, to locat the hole.
Any body have any ideas?
Check out the screenshot I attached. It's from the steel manual of ASD.
After you activate the snapping options, you could use the hole's tools better.
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register