I am slowly working through most of the problems--Kinda
Here is the new one.
When I draw a model of a simple frame. I added baseplates, 4 x 4 HSS, and shear plates, and 1 W 8 x 18. I drew it using the front view. Up is up, left is left and so on and so one.
I then assign positions for everything a position.
Next I create automatic drawings of the assembly.
It does everything as it sould, but too many dimension. I am working on that.
The problem is the Top, Front, and side view. None of these are correct. The front is the side, the side is not labled, and the top view is listed as a side view, and it is also upside down. I think this is the bottom view, because the HSS is shown in red (hidden) and the shear plate is on the wrong side.
How do I change this?
As I remember, the view where dependent on UCS (hope I'm not wrong).
What I've done was to create a Drawing template with all the necessary views (Fron, Back, Left, Right, Up, Down) and use the Automatic Drawing. Then on the sheet I left only what side was usefull.
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register