AutoCAD Structural Detailing General DIscussion

Reply
Active Member
lanzman
Posts: 8
Registered: ‎06-04-2012
Message 1 of 2 (441 Views)

Threaded hole?

441 Views, 1 Replies
06-04-2012 10:53 PM
Is it possible to make a threaded hole with ASD 2012? or is there any posibility to mark some holes as threaded hole? (automatical)
Valued Contributor
tedmail
Posts: 86
Registered: ‎04-26-2011
Message 2 of 2 (419 Views)

Re: Threaded hole?

06-06-2012 10:07 AM in reply to: lanzman

I have not seen the option to have a threaded hole, however, I have used the bolt command to add in a bolt without a washer or nut and label it "PIN" in the description.  It doesn't change the image from having a hex head, but it is noted with the bolt and can be referanced in tags later.

 

Hope that helps.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community