AutoCAD Structural Detailing General

Reply
Active Member
jasonstojakovich7363
Posts: 8
Registered: ‎02-01-2012
Message 1 of 2 (511 Views)
Accepted Solution

Staircase landings help

511 Views, 1 Replies
03-13-2013 10:44 AM

I am trying to create at staircase that starts at ground level, leads to a door @ 11'-0" and continues another 20'-8" opp direction. My problem is that I can not seem to change the # of levels under the parameters of the generator. It keeps showing 9 landings when I know OSHA mandates only after 12'-0" do i need a landing. And to my next point can i create a continious landing on my 2nd stringer. I have attached SC of my drawing this was mainly for practice purposes as I am new to the program. Thanks to all in advance.

Active Member
jasonstojakovich7363
Posts: 8
Registered: ‎02-01-2012
Message 2 of 2 (416 Views)

Re: Staircase landings help

03-22-2013 05:52 AM in reply to: jasonstojakovich7363

Thanks to Jakub from Autodesk he was able to provide a pretty easy answer for those who are having this problem. You need to DEL the top level once the levels are auto populated and use the change level command to enter in the top elev of the stairs and adjust the number of treads. IE  stair height 12'-0". Program populates 4 levels @ 0',4',8'12'. You would delete the top level down to the 4' level and then change level to 12' for a cont stringer.  And again thanks to jakub.!

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community