AutoCAD Structural Detailing General

Reply
Active Member
Posts: 9
Registered: ‎11-11-2008
Message 1 of 2 (408 Views)

Making slight changes to connections

408 Views, 1 Replies
10-18-2010 01:07 AM

Hi.

 

Something I've encountered while working with ASD is that you cannot make slight modifications to a connection without it defaulting back to how it was. For example, there is not option to give a plate a horizontal offset in a connection, so when I go and manually move a plate after placing the connection it will move and look fine, until I either update or modify the connection.

 

I understand why it does this, but our South African standards aren't fully catered for in ASD, so then the easiest workaround is to create a connection and then modify it to suite our standards.

Does anyone perhaps know if there's a way to explode a connection so that these minor changes will be possible?

 

Thanks!

Valued Contributor
tony
Posts: 62
Registered: ‎02-08-2011
Message 2 of 2 (255 Views)

Re: Making slight changes to connections

02-08-2011 08:16 PM in reply to: danielledew

You can try to save the connection after you make the changes then It shouldn't default back

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community