AutoCAD Structural Detailing General

Reply
Active Member
Posts: 7
Registered: ‎07-23-2012
Message 1 of 3 (455 Views)
Accepted Solution

Connection Shearplate - Beam_column web at an Angle

455 Views, 2 Replies
07-23-2012 08:59 PM

Hi,

 

The "Connection Shearplate - Beam_column web"  does not work when the beam is connecting to the column in an angle postion. What is the work around? Or is there any other connection type that can be use with this situation?

 

Please see attach picture below for reference:

 Connection Shearplate - Beam_column web at an Angle.png

 

Thanks,

Job

Product Support
Jakub.Brozonowicz
Posts: 314
Registered: ‎12-13-2010
Message 2 of 3 (442 Views)

Re: Connection Shearplate - Beam_column web at an Angle

07-24-2012 06:21 AM in reply to: job_delacruz

It is possible only for very small angle positions ~1 degree.

Only manual adjusting is possible for bigger angles.

---------------------------------------------
If this post answer your question please click "Accept as Solution". It will help everyone to find answer more quickly!



Jakub Brożonowicz
Active Member
Posts: 7
Registered: ‎07-23-2012
Message 3 of 3 (429 Views)

Re: Connection Shearplate - Beam_column web at an Angle

07-25-2012 06:13 PM in reply to: Jakub.Brozonowicz

Ok, noted. Can you show me an example of the manual adjustment if the column rotate more than 1 degrees.

 

Job

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community