AutoCAD Structural Detailing General

Reply
Contributor
ibnmessaoud10
Posts: 13
Registered: ‎04-24-2010
Message 1 of 2 (804 Views)
Accepted Solution

Bracing type V or K

804 Views, 1 Replies
08-26-2012 01:58 AM

in macros ,only X bracing is done in ASD;

if someone can give a short video to do ( manually) other bracings such as V (inversed) or K .

I tried to use plate welded to profile flange (wich are defined in XY plane),and use machining command to do this...

Product Support
Jakub.Brozonowicz
Posts: 314
Registered: ‎12-13-2010
Message 2 of 2 (781 Views)

Re: Bracing type V or K

08-27-2012 08:29 AM in reply to: ibnmessaoud10

Please look here where I showed some idea.

---------------------------------------------
If this post answer your question please click "Accept as Solution". It will help everyone to find answer more quickly!



Jakub Brożonowicz

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community