AutoCAD Structural Detailing General

Reply
Contributor
detailer_wsa
Posts: 13
Registered: ‎03-06-2012
Message 1 of 4 (889 Views)

Bending A Plate

889 Views, 3 Replies
04-10-2012 02:58 PM

Hello every one I need help on bending a plate  I keep on getting the same message eventhough I change the ucs view

Here is how I do it :

 

Command: '_-view Enter an option
[?/Delete/Orthographic/Restore/Save/sEttings/Window]: _right Regenerating model.

 

Command: 3do
3DORBIT Press ESC or ENTER to exit, or right-click to display shortcut-menu.
Regenerating model.

Command: _RBCS_bentplate
Select plate(s) :1 found
Select plate(s) : Choose method [by2points/byLine]<by2points>:L
Select line: Location of bending line[Center/Edge] <Center>
Specify internal radius or [Axial] <0.125000>:
Specify angle <90.000000>
Pick side to be wrapped :
*** Cut plane does not intersect selected part #1 ***

 

I changed the view to all views to WORLD, TOP, BOTTOM, LEFT RIGHT, FRONT & BACK  but the error is always the same :  *** Cut plane does not intersect selected part #1 ***

 

Thank you very Much

PEDRO E

Product Support
Jakub.Brozonowicz
Posts: 317
Registered: ‎12-13-2010
Message 2 of 4 (878 Views)

Re: Bending A Plate

04-11-2012 01:49 AM in reply to: detailer_wsa

Could you pleae share the file with a plate to check?

 

Thanks



Jakub Brożonowicz
Contributor
detailer_wsa
Posts: 13
Registered: ‎03-06-2012
Message 3 of 4 (866 Views)

Re: Bending A Plate

04-11-2012 08:56 AM in reply to: Jakub.Brozonowicz

Here is the file of the bent plate I cant bend. the white lines are the bending point

Valued Contributor
tedmail
Posts: 86
Registered: ‎04-26-2011
Message 4 of 4 (773 Views)

Re: Bending A Plate

05-24-2012 08:28 AM in reply to: detailer_wsa

I assume it just doesn't work?  I get the same results as described and have not been able to bend the plate.

 

Actually, after finally playing around with it quite a bit, and knowing I tried these exact same steps before, I was able to get the bend done.  Things to take note of:

 

The Z coordinate should be perpendicular to the face of plate.

180 degree bend is actually not a bend at all, but keeping it flat.

The radious should be .1 and go up from there to get your desired bend.

 

But at least it gets the job done...

 

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community