AutoCAD Structural Detailing General DIscussion

Reply
Contributor
Scrambled
Posts: 13
Registered: ‎09-21-2012
Message 1 of 5 (417 Views)

Automatic drawings

417 Views, 4 Replies
11-04-2013 12:58 AM

I have a question about the automatic drawings.

 

I draw a lot of iron industrial and residential railings.  Is there a way that the automatic drawings can place a mark on the center of the flatbar or channel where we need to punch the holes for the pickets.

 

Right now when I do the automatic drawings that use 1/2 x 1 bar channel, for the horizontal member of the handrail and 1/2 x 1/2 square bar for the pickets.  The automatic drawings show me the correct length to cut both the 1 x 1/2 bar channel, and the 1/2 x 1/2 square bar with the correct piece count, but it does not show me the location to punch the square holes so that the bar channel and sq bar can be assembled and welded together.

 

Is there a way to include the holes, or am I going to have to keep adding them manually ?

 

Thanks

 

 

Steve

Active Contributor
jenyzosin
Posts: 38
Registered: ‎04-27-2009
Message 2 of 5 (399 Views)

Re: Automatic drawings

11-04-2013 05:06 AM in reply to: Scrambled

hy

check settings

here is a sample

There's a fine line between genius and insanity. I have erased this line - O.L.
Mentor
zcsillag
Posts: 246
Registered: ‎02-01-2008
Message 3 of 5 (369 Views)

Re: Automatic drawings

11-04-2013 12:59 PM in reply to: jenyzosin
And ???
Regards
Csillag Zoltán
Contributor
Scrambled
Posts: 13
Registered: ‎09-21-2012
Message 4 of 5 (360 Views)

Re: Automatic drawings

11-04-2013 09:18 PM in reply to: jenyzosin

jenyzosin                         

 

I tried to follow your directions, but I did not have any luck.

 

Do you have any more suggestions?

 

 

When I change the style, do I need to create a new drawing, or just update the existing drawings?

 

 

Thanks for the help

 

 

Steve

Active Contributor
jenyzosin
Posts: 38
Registered: ‎04-27-2009
Message 5 of 5 (353 Views)

Re: Automatic drawings

11-05-2013 12:30 AM in reply to: Scrambled

Just update your drawing

There's a fine line between genius and insanity. I have erased this line - O.L.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community