AutoCAD Structural Detailing General DIscussion

AutoCAD Structural Detailing General DIscussion

Reply
Member
RogerZimmer
Posts: 4
Registered: ‎07-01-2010
Message 1 of 2 (293 Views)

Adding Triangular Plates and Other Questions

293 Views, 1 Replies
02-02-2011 07:39 PM

What is the procedure for adding plates to an ASD model when the plates are not circular and not square?

 

also . . . the attached screen shot shows my default dialog box when I activate the plates command in ASD modeling ribbon.  It always defaults to a 10" plate, no matter how many times I insert a plate.  Also the dialog box only seems to recognize / default whole numbers, 1,2,3 etc, no decimals. 

 

I suspect this has something to do with inch to millimeter conversion(s).  Anybody have any ideas?

Contributor
edugarge
Posts: 21
Registered: ‎10-08-2010
Message 2 of 2 (274 Views)

Re: Adding Triangular Plates and Other Questions

02-03-2011 12:29 PM in reply to: RogerZimmer

Please, you must read the manual. It has all the answers to your questions and more!

(You can find it in your own PC... C:\Program Files\Autodesk\AutoCAD Structural Detailing 2011\Setup\es-ES\SetupRes\InfoLink\...)

 

Chapter 2.1.3 Units (defining units, metric, imperial, etc)

Chapter 7 Plates (user defined plates, like polylines > triangular)

 

There are Tutorials and some Getting Started Guides.

Try them.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community