AutoCAD Structural Detailing General

Reply
Active Contributor
Posts: 40
Registered: ‎11-09-2008
Message 1 of 1 (263 Views)

ASD/ Reinforcement/splice length scale factor

263 Views, 0 Replies
05-04-2009 01:31 AM
If the scale factor ( the value multiplied by the bar diameter in Job prereference ) of the bar lap splice has been changed, the lap length is not affected in surface distribution option.

If the bar diameter ( in surface distribution fill-in form ) has been changed, the lap length is not affected in surface distribution option.


I enter the splice length value manually!!!

Please advise and help. Edited by: abbakeer on Jun 9, 2009 5:45 AM

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Structural Detailing Category!

The AutoCAD Structural Detailing forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community