AutoCAD Structural Detailing
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
ASD 2013 - Limited number of layout tabs?
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
371 Views, 3 Replies
09-25-2012 11:13 AM
I am able to create up to 5 tabs per model and file, but if I try to create another layout, I lose a layout tab or two.
Re: ASD 2013 - Limited number of layout tabs?
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
09-25-2012 12:06 PM in reply to:
csammons
You did't lose it... Look in your "printouts" tab in the object inspector. If you aren't using the "object inspector" you will have a tough time in ASD.
Re: ASD 2013 - Limited number of layout tabs?
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
09-25-2012 01:10 PM in reply to:
tedmail
Many thanks. I am using the Object Inspector. I can see the Prinouts, but the number of Layout tabs is limited. I can work around this, but it does not seem necessary to limit the number of layout tabs.
Re: ASD 2013 - Limited number of layout tabs?
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
09-25-2012 04:42 PM in reply to:
csammons
I found this bit of information-
type-- setpbuf in the command line. Change the 5 to 30.
now you get 30 views.
Steve
