AutoCAD Raster Design General

Reply
New Member
Posts: 1
Registered: ‎05-05-2010
Message 1 of 1 (195 Views)

Do projection transforms work using iinsert from command line?

195 Views, 0 Replies
05-05-2010 06:46 AM
Using the GUI, the Image/Insert will transform a geotif from one projection to another successfully. However, I need to run the iinsert command from the command line and discovered that the transform was not performed. I am trying to insert a georeferenced tif into a dwg. The projections differ in the tif and the dwg, and the command when run from the command line does not perform the transform. The environment is Map3D 2007 and Raster 2007, the command is being called from VBA. This will also need to work in Map/raster 2011.

Id their a command line argument I can use? Is this just not possible? Any assistance would be appreciated.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Raster Design Category!

The AutoCAD Raster Design forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community