Hi Bill,
ISOGEN in picky about titleblocks or backing sheet ISOGEN refers to it. The best way to configure it is to do in steps to ensure that your changes will work properly.
Start by creating a simple line. Dont use the largest and most complicated because you will be running multiple times.
You will need to understand how to add you title block to the project
Go to project setup -> Plant 3D DWG settings -> Isogen Settings -> Paths.
once there direct the location of your title block DWG file through the browser button
Note that the titleblock DWG file must contain the title block as an autocad block in order to be seen in Block Editor.
Now back out of project set-up by pressing Apply then OK
Run your iso to ensure that the title block works
If you recieve an error open dwg purge and audit and try again.
Once you have the border working, now you can go into Project setup / title block editor and apply changes
Mike G
Michael Gulnac
Technical Specialist
Organization
Autodesk, Inc.