AutoCAD Plant 3D General

Reply
Active Contributor
tarheels09
Posts: 35
Registered: ‎02-22-2013
Message 1 of 1 (153 Views)

Workflow

153 Views, 0 Replies
02-22-2013 01:18 PM

I have an existing Revit Model of a water plant that I need to add existing and new piping to. The plant is multi-story

and the piping will be on different floors. When I attach a .dwg from revit to plant 3d 2013  how do I clip each floor so I can see the correct floor to place pipe. New to program and I am just trying to figure out the proper workflow.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community