AutoCAD Plant 3D Forum
Welcome to Autodesk’s AutoCAD Plant 3D Forums. Share your knowledge, ask questions, and explore popular AutoCAD Plant 3D topics.
cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 

View goes to extents after placing pipe component

4 REPLIES 4
SOLVED
Reply
Message 1 of 5
aredling
429 Views, 4 Replies

View goes to extents after placing pipe component

After I place a pipe componenet (ball valve, needle valve, etc...) the model views way out to show 100% of the extents as I specify the angle/orientation of the component.  

 

Anyone ever seen this?  How do I reset this setting?

 

thanks,

4 REPLIES 4
Message 2 of 5
Asimo5000
in reply to: aredling

Is this right after you place the component, and then click on the view cube?
Message 3 of 5
pendean
in reply to: aredling

What is UCSFOLLOW variable set to?
Message 4 of 5
aredling
in reply to: pendean

This occurs as the angle to place the component is being set.  So as soon as I click the component location in the model it zooms all the way out to the model extents, then I have to set the angle (which makes it almost impossible to do).

 

This must be a setting because none of the other models I have do this.

 

UCSFOLLOW: 1

 

thanks,

Adam

Message 5 of 5
aredling
in reply to: pendean

I checked the other models and UCSFOLLOW was 0. 

 

Sure enough this problem was fixed when I updated from 1 to 0.

 

Thanks A MILLION!

 

-Adam

Can't find what you're looking for? Ask the community or share your knowledge.

Post to forums  

Autodesk Design & Make Report

”Boost