AutoCAD Plant 3D General

Active Member
Posts: 7
Registered: ‎12-03-2009
Message 1 of 2 (189 Views)

Retain Isometric Annotations

189 Views, 1 Replies
02-23-2010 07:38 PM
If I create an isometric drawing and add an annotation to the face of it, it gets removed if I have to run the iso again. There are lots of circumstances that annotations need to be retained is this possible in Plant 3D? I know it can be done in other programs that use isogen.
Posts: 74
Registered: ‎08-08-2008
Message 2 of 2 (189 Views)

Re: Retain Isometric Annotations

02-25-2010 02:36 PM in reply to: t-mcconnell
currently our isogen generation does not retain any information from previouse iso's. It will overwrite the file if the option is checked or create the same file with an alpha designator ie 100 and 100A.

You can add annitations and notes to the model on the Iso ribbon tab with Isogen Messages and Isogen Info functions. These will then be transfered to the isometric drawing

Mike G

Michael Gulnac
Technical Specialist
Autodesk, Inc.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community