AutoCAD Plant 3D General

New Member
Posts: 1
Registered: ‎02-03-2013
Message 1 of 2 (197 Views)

Rectangular ducting

197 Views, 1 Replies
02-03-2013 07:30 PM



I use 3D plant for Coal Processing Plant detail design, most of the equipment use chute and rectangular ducting as solid transfer, how to set up rectangular duct in 3D plant.


best regard



Active Contributor
Posts: 45
Registered: ‎11-18-2010
Message 2 of 2 (181 Views)

Re: Rectangular ducting

02-04-2013 05:02 AM in reply to: erenst

Unless AD has released a new catalog, there is no option for duct work. You could create custom components, but I would imagine it would be a good bit of work. If you look at the spec editor, there are placeholder box fittings, but I didn't see any options for straight box shapes. You'd have to build it custom.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community