AutoCAD Plant 3D General

Reply
Mentor
PatrickByrne
Posts: 164
Registered: ‎10-06-2010
Message 1 of 3 (482 Views)
Accepted Solution

Problems with Stub Flanges and Collars

482 Views, 2 Replies
07-10-2012 02:39 AM

Stub Flanges: In the attached sample I have 2 pipes joined by stub flanges, this works well in the model until I go to produce an Isometric. The resulting Isometric is in 3 pieces and the Isometric with the stub flanges only shows 2 welds and does not list the stub flange in the material list. I would like the stub flanges and lap flanges to appear in the material list as a separate items.

 

The End type for the Pipe is PL PL

The End type for the stub flange is LAP PL with an SKEY FLSE

The End type for the Lap Flange is FL LAP with a SKEY FLFL

 

Collars: Other pipework uses collars on the end of the pipe and bends with a lap a flange behind it. Once again this models correctly but the resulting Isometric does not show any flanges where the collar and lap flange are located. End types and SKEY’s are similar to above.

 

Thanks for your help.

Mentor
PatrickByrne
Posts: 164
Registered: ‎10-06-2010
Message 2 of 3 (480 Views)

Re: Problems with Stub Flanges and Collars

07-10-2012 02:45 AM in reply to: PatrickByrne

Just to add, I am using Plant 3D 2012

Mentor
PatrickByrne
Posts: 164
Registered: ‎10-06-2010
Message 3 of 3 (456 Views)

Re: Problems with Stub Flanges and Collars

07-10-2012 08:48 PM in reply to: PatrickByrne

Found the solution.

 

When I converted the cadWorx stub ends across it set the Iso Symbol Type as LAPJOINT-STUB-END it should have been LAPJOINT-STUBEND

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community