Ortho Editor and Current view

[JohnHolder]

Any else have issues with getting it to actually work?

Normally it defaults to top view.

I've tried setting the UCS with the UCS and VIEW commands then current view - ends up with a default top view

I've tried clicking the view cube and then current view - ends up with a default top view

I've tried clicking the view cube and then UCS and View commands then current view - ends up with a default top view.

but if I do the above, then click on top bottom right left etc and THEN click on current view - *sometimes* it works.

A random chance?! for this to work is incredably annoying.  This isn't a specific drawing issue either. This has been happening

on multiple drawings.

One would think that when you click on current view it will work and use the 'current view'

[quentin.contreras]

Mine is not defaulting to the Top View. Here is where mine is defaulting.

[JohnHolder]

Always the top view.