AutoCAD Plant 3D General

Reply
Distinguished Contributor
Posts: 113
Registered: ‎03-06-2008
Message 1 of 5 (395 Views)

ISO PROBLEMS - SPLIT POINT & DIM to POINT

395 Views, 4 Replies
09-01-2012 01:18 PM

Hi,

I'm having a little trouble in tweaking my Isos - when using the lap joint & spin flange they tend to break for continuation at the lap joint b/w & not on the gasket face. Also they seam to want to dimension to the lap joint b/w & not to the gasket face see attached PDF example.

Any helpers?

 

Regards

Gary

Product Support
Posts: 286
Registered: ‎03-05-2010
Message 2 of 5 (311 Views)

Re: ISO PROBLEMS - SPLIT POINT & DIM to POINT

10-04-2012 09:53 AM in reply to: MOLGRAND

Hi,

 

Do you have a small example project that you can provide for testing here?

 

Thanks,
Dan

 



Dan Scales
Distinguished Contributor
Posts: 113
Registered: ‎03-06-2008
Message 3 of 5 (307 Views)

Fwd: ISO PROBLEMS - SPLIT POINT - 1 of 2

10-04-2012 10:56 AM in reply to: Dan.Scales
Hi, See attached. I have attached one of the models from a large project, along with PDF files of the Isos I ran off & a PDF of the g/a which was print from the Otho drg produced. I hope you can help as it makes the ISO drgs difficult to work with - at the moment I have 3000 Isos! Regards Gary Randall
Product Support
Posts: 286
Registered: ‎03-05-2010
Message 4 of 5 (294 Views)

Re: ISO PROBLEMS - SPLIT POINT & DIM to POINT

10-05-2012 06:21 AM in reply to: MOLGRAND

Hi,

 

The drawing doesn't seem to have been uploaded.

Could you try again?

 

Thanks,
Dan



Dan Scales
Distinguished Contributor
Posts: 113
Registered: ‎03-06-2008
Message 5 of 5 (291 Views)

Re: ISO PROBLEMS - SPLIT POINT

10-05-2012 07:25 AM in reply to: Dan.Scales
Hi, Drg attached again Cheers

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community