AutoCAD Plant 3D General

Reply
Valued Contributor
Posts: 54
Registered: ‎10-26-2009
Message 1 of 1 (73 Views)

Filter by Spec when generate ISO

73 Views, 0 Replies
05-27-2012 09:15 AM

Hi

 

Is there anyway that when we generate ISO we can filter by SPEC or service not by Linenumber?

it is a real requirement from most of customers.

and it can be done in AutoPLANT in the anvanced selection mode.

So maybe it can be wishlist in your later development.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community