AutoCAD Plant 3D General DIscussion

Reply
Member
marodi
Posts: 4
Registered: ‎08-11-2011
Message 1 of 1 (170 Views)

FLANGED PIPE CONNECTION

170 Views, 0 Replies
08-21-2012 05:36 AM

Hello Everyone!

 

How can you make the following:

I want to put down pipe segments(in a straight line), and I want them to be separated with

flanged connections. I want the flanges to be created automatically(not putting manually,

after the pipe creation). Is it possible?

I tried:

1. Pipe with FL ports, but after that, the software put only on side of the flange, with a gasket,

and a bolt set, and no other side of the flange.

2. Plant3D parametric graphics(v2013)(with flange endings, but this does not seems to look good, when I put them

down, there are empty spaces between the pipe's end and the gasket.

Can anyone write me the proper way of doing this?

 

Thank You!

 

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community