AutoCAD Plant 3D General DIscussion

Reply
Contributor
HEANRorkraft
Posts: 21
Registered: ‎02-23-2012
Message 1 of 6 (135 Views)

Double tag numbers on isometrics

135 Views, 5 Replies
09-18-2012 05:39 AM

Why do I get the tag numbers for valves, supports etc. twice in the "Bill of Materials"? Everything is doubled in this column and I don't understand why. 

 

This is Plant 2013.

Employee
TomislavGolubovic
Posts: 534
Registered: ‎12-01-2010
Message 2 of 6 (118 Views)

Re: Double tag numbers on isometrics

09-18-2012 12:39 PM in reply to: HEANRorkraft

Can you post the model here please?



Tomislav Golubovic
Plant Solutions Engineer
Autodesk Australia / New Zealand
Autodesk, Inc.

Contributor
HEANRorkraft
Posts: 21
Registered: ‎02-23-2012
Message 3 of 6 (116 Views)

Re: Double tag numbers on isometrics

09-18-2012 01:49 PM in reply to: TomislavGolubovic

I have attached the complete Iso-folder with all the settings. My guess is that the source to my problem hides in the configuration files somewhere. All my colleagues at the office have the same problem. I have created an iso to display the problem. Please have a look at the BOM-list.

 

I have also tried to create a complete new project with all default settings. Then I routed a single pipe with one pipe support. In the BOM-list on the iso the tag number of the support still appears twice! So it's not a setting in my specific project.

Employee
TomislavGolubovic
Posts: 534
Registered: ‎12-01-2010
Message 4 of 6 (109 Views)

Re: Double tag numbers on isometrics

09-18-2012 04:34 PM in reply to: HEANRorkraft

Just as a side note, can you just upload one of the models, don't think its going to matter, but just in case, so I don't have to ask later :smileyhappy:



Tomislav Golubovic
Plant Solutions Engineer
Autodesk Australia / New Zealand
Autodesk, Inc.

Contributor
HEANRorkraft
Posts: 21
Registered: ‎02-23-2012
Message 5 of 6 (101 Views)

Re: Double tag numbers on isometrics

09-18-2012 11:17 PM in reply to: TomislavGolubovic

The model is too big for your forum requirements. I can use a file transfer service but then I need your e-mail.

Employee
TomislavGolubovic
Posts: 534
Registered: ‎12-01-2010
Message 6 of 6 (99 Views)

Re: Double tag numbers on isometrics

09-18-2012 11:34 PM in reply to: HEANRorkraft

Please send me a PM with your email and I can email you directly.



Tomislav Golubovic
Plant Solutions Engineer
Autodesk Australia / New Zealand
Autodesk, Inc.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community