Dimension Threaded elbow/valves

[thebearjed]

this is the first time i have extracted a threaded iso. why is it dimensioning like this on the elbows/valve? all other isos have done the overall dimension...center of elbow to center of elbow.

[jenakap1]

The valve dimensioning is controlled by valve dimensioning behavior setting.  See attached. Can you post your PCF file so we can take a look at the elbow.  Thanks.

 

[thebearjed]

yes. i have set the valve to dimension to the center already.

[IanMatthew · Accepted solution]

Hi Jedmxr,

Take a look at the two images I have attached.  The first is an iso I created of threaded components - I believe this is what you are looking for.  the second is of the Iso Dimensioning Configuration properties page - check your setup against mine.

Hope this helps

[thebearjed]

apparently threaded fitings are classified as miscellaneous. unchenking Miscellaneous fittings in all 3 catagories does the trick. thanks.