AutoCAD Plant 3D General

Reply
New Member
poppe84
Posts: 1
Registered: ‎10-17-2011
Message 1 of 2 (134 Views)

Centerline when bending?

134 Views, 1 Replies
10-17-2011 06:38 AM

Hi, how do I create sections of bends with correct centerlines in Plant 3D?

See attached word docoment for more information.

 

Best regards

 

Christofer Larsson
Dir: +46 8 462 65 71 | Mob: +46 767 85 22 62
christofer.larsson@norconsult.com

Energi, Luft & Rörteknik
Norconsult AB
Hornsbruksgatan 19, 117 34 Stockholm

Tel: +46 31 50 70 00

www.norconsult.se

 

Valued Mentor
Rich.O.3d
Posts: 519
Registered: ‎08-19-2008
Message 2 of 2 (118 Views)

Re: Centerline when bending?

10-17-2011 05:35 PM in reply to: poppe84

so far the answers ive had are that you will hae to live with the straight CLs...try doing a flex hose as a custom part and see the rubish output you get on orthos....I hope they fix this sooner (hot fix for 2012 or for 2013), rather than later (which i suspect is more likely).

CAD Management 101:
You can do it your own way,
If its done just how I say!
[Metallica:And Justice For All:1988]

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community