AutoCAD Plant 3D General

Reply
Valued Contributor
vannmannen
Posts: 57
Registered: ‎12-16-2011
Message 1 of 2 (316 Views)

Bolt deviation on isometric

316 Views, 1 Replies
11-27-2012 08:54 PM

Bolt issues seems to be quite normal for plant 3D...

 

Take a look at the attachment. The bolt size/length comes out as mixed imperial/metric.

In the spec: both the bolt size and the length is in inches, while on the isometric it comes out as inches X mm.

So my 300# spec sais 1" bolt with legth of 6.25" for 10" flange. While the isometric gives me 1"x159 (which is clearly mm) and I need them BOTH in inches on the iso...

 

I have tried older posts and set up in the spec editor but have not found any solution....

Product Support
gersteb
Posts: 165
Registered: ‎09-20-2010
Message 2 of 2 (233 Views)

Re: Bolt deviation on isometric

12-04-2012 02:52 AM in reply to: vannmannen

Hi Trygve,

 

This happens when you have created a mixed (metric/british) project. Unfortunately the PipelinesSettings.xml does not work here. I have logged this issue to our development department. Currently you have to create a british project to get the right bolt set ND in the BOM of the isometric.

 

Regards

Bernd



Bernd Gerstenberger

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community