AutoCAD Plant 3D General

Reply
Valued Mentor
ybogdanov
Posts: 385
Registered: ‎07-07-2011
Message 1 of 2 (158 Views)

Bolt Sets make existing without Ctrl

158 Views, 1 Replies
03-07-2013 11:27 AM

Hello,

when is selected pipe run, is posible to switch the status to Existing. But in this case Bolt Sets is not set. It's necessary to select each Bolt connection with Ctrl pulsed... I think that it's posible to resolved, because gaskets it's fastener too and it's posible to change status without pulsed Ctrl.

-----------------------------------------------------------
Yury Bogdanov
ASIDEK(Grupo CT) - Partner Directo de Autodesk
Barcelona (Spain)
Contributor
feschaurich
Posts: 19
Registered: ‎02-13-2013
Message 2 of 2 (93 Views)

Re: Bolt Sets make existing without Ctrl

06-27-2013 12:30 PM in reply to: ybogdanov

Someone found the solution for this problem?

 

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community