AutoCAD Plant 3D General

Posts: 448
Registered: ‎11-28-2007
Message 1 of 3 (397 Views)

Adding tube fitting components to spec

397 Views, 2 Replies
12-12-2012 09:12 AM

I am setting up a pipe spec which uses Swagelok tube fittings with the "two-ferrule, mechanical grip design". There is a front and back ferrule which are enclosed in a nut. A seal is formed when the nut tightens on the 2-ferrule assembly.

   I was wondering how to represent it in a pipe spec. Should I keep all the components seperate, what "end conditions" should I use for the ferrules and would this sort of connection come under a "flanged" or "collared"  auto-joint in Plant?

Active Contributor
Posts: 45
Registered: ‎11-18-2010
Message 2 of 3 (388 Views)

Re: Adding tube fitting components to spec

12-12-2012 02:41 PM in reply to: tmccar

The connections are still basically threaded connections. We used these in AutoPLANT and I just built them using threaded fittings. I don't see a need to build them as a special connection since they are still male and female connections. You will just need to build the components per the cut sheets. There might have to be a work around for some of the components, but the general tube, fittings and valves should function just fine.

Posts: 448
Registered: ‎11-28-2007
Message 3 of 3 (382 Views)

Re: Adding tube fitting components to spec

12-12-2012 03:37 PM in reply to: rchiasson

OK, thanks. What "end condition" did you use? THDM?  And how many ports (1 or 2)?



You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD Plant 3D Category!

The AutoCAD Plant 3D forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community