AutoCAD P&ID
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
Substituti
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
153 Views, 0 Replies
11-26-2007 05:35 AM
Hi
When using the P&ID ISO standard the “Substitution grip” palette on a nozzle is not shown then picking the grip.
If I do the same using the P&ID PIP standard, it is possible to change the nozzle type!
Where is the trick for setting this up?
Best regards
Ulla Frederiksen
When using the P&ID ISO standard the “Substitution grip” palette on a nozzle is not shown then picking the grip.
If I do the same using the P&ID PIP standard, it is possible to change the nozzle type!
Where is the trick for setting this up?
Best regards
Ulla Frederiksen
