AutoCAD P&ID

[#1]

I wanted to change the order of the Pipeline tag, so i did so. Now some of the attributes will not show up at all. I switched it back to its original order and it did not change anything. Did i mess everything up?

[#2]

I too wish to rearagne the order of the pipe line tag and I also wish to add in a another sub-part, only the sub-poart that i need to add doesn't yet exisit. I need to add an owner to the line number. I my case I have 4 areas of a plant all named, and each line number has an abbrevation for that plant so we know where abouts the line orginated from.
How and where do i add thsi information?

Also how does one edit things like the fluid codes and the specs to suite my project.

[#3]

Another forum user "flowers" gave me some good advice recently (Any good tutorials)... Review the getting started guide that comes with the install. With regard to this particular thread, refer to chapter 5 of the getting started guide (AutoCAD P&ID 2010) page 82 "Set Up Tag Formatting", it should help.

Regards

Tim

[#4]

Mel,

Go to the project manager and right click on the project. Select properties.
In the project properties/setup you can edit the specs, services, etc.

Peter Quinn (Autodesk)
wrote in message news:6312925@discussion.autodesk.com...
I too wish to rearagne the order of the pipe line tag and I also wish to add
in a another sub-part, only the sub-poart that i need to add doesn't yet
exisit. I need to add an owner to the line number. I my case I have 4 areas
of a plant all named, and each line number has an abbrevation for that plant
so we know where abouts the line orginated from.
How and where do i add thsi information?

Also how does one edit things like the fluid codes and the specs to suite my
project.