I just upgraded to P&ID 2011 just to find that the bug has yet not been fixed. You still cannot use the stretch command.
I find it extremely disturbing not being able to use one of the most fundamental commands without messing up the drawing.
Yes, I am using 2011. To confirm the problem, I just started a new project and created a new drawing with 8-10 components. Stretch messes up the drawing. The problem occurs when the objects I want to move is connected to other objects (that I don't want to move), but preserving connection to other objects is the whole point of using stretch.
With 2009 we had problems:
The missing of the functionality of Autocad STRETCH and MOVE commands was the major weakness of Autocad P&ID 2009.
I have understood that performance of "P&ID" has improved since 2009.
But it seems that there are still problems with connection between diagram and database with P&ID2010 as described in post Major problems using Autocad P. We had so big problems with 2009 that we had to start again with our previous tool.
I think Autocad P&ID would be nice tool without problems described above and equipped with autocad functionality for stretching and moving diagram. Stretching is important because you have to make space for new equipment many times during project.
Making nice "P&ID"-tool on top of Autocad seems to be too timeconsuming job for Autodesk.
Are there any hot fixes for the move command "BUG" for AutoCAD P&ID 2013? This is still a major problem. Our client decided to goto a smaller titleblock. I have over 300 drawings that need to placed on a smaller titleblock. I have hundreds of components on each drawing. When I move them there are many problems with lines and instrumentation.
I have found that using the classicgroup command, grouping the objects you want to move, then setting your pickstyle to 1 (ctrl + h), then moving the group works. You won't end up with objects/lines all over the place or control valve diaphragms everywhere. From that you can leave the group or not, you can always select sub-objects of the group with the pickstyle set to 0.
Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register
Start with some of our most frequented solutions to get help installing your software.
The AutoCAD P&ID forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.
|AutoCAD P&ID General|