AutoCAD P&ID General

Reply
Member
Posts: 4
Registered: ‎03-20-2007
Message 1 of 3 (334 Views)

Refedit

334 Views, 2 Replies
03-20-2007 03:14 AM
Does anybody else also has problems with the command refedit in AutoCad P&ID 2007? I can edit some blocks in drawings in AutoCad 2007, but within the P&ID software the command ends up in *cancel*.
Anybody any idea?
*Jorge Lopez
Message 2 of 3 (334 Views)

Re: Refedit

03-20-2007 03:50 PM in reply to: edvanno
Refedit is disabled in P&ID if and only if P&ID entities are involved. If
you encountered this problem without P&ID entities involved then let me know
so I can log a defect against the feature. We will implement the necessary
extensions to have our entities participate in Refedit in a future release.

"edvanno" wrote in message news:5524018@discussion.autodesk.com...
Does anybody else also has problems with the command refedit in AutoCad P&ID
2007? I can edit some blocks in drawings in AutoCad 2007, but within the
P&ID software the command ends up in *cancel*.
Anybody any idea?
Member
Posts: 4
Registered: ‎03-20-2007
Message 3 of 3 (334 Views)

Re: Refedit

03-20-2007 11:42 PM in reply to: edvanno
Jorge,

The refedit problem occours when I am in standard AutoCad within AutoCad P&ID 2007. I checked and in the P&ID setting I get the same reaction of the command.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD P&ID Category!

The AutoCAD P&ID forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community