AutoCAD P&ID General

Reply
Valued Contributor
Posts: 83
Registered: ‎03-26-2007
Message 1 of 2 (364 Views)

Printing lineweights

364 Views, 1 Replies
03-26-2007 10:52 AM
I am using AutoCAD 2007 P&ID Demo and am having problems printing the lineweight. It is just too big. Is it just me?
*Peter Quinn
Message 2 of 2 (364 Views)

Re: Printing lineweights

03-26-2007 11:03 AM in reply to: hinde
Hinde,

No, the default lineweights are quite thick. They're based on what's called
out in the standards. We made the decision to go with what the standards
said even though many of us think they're way to fat. You can change them in
project setup to be any thinkness you like.

Peter Quinn (Autodesk)

wrote in message news:5531040@discussion.autodesk.com...
I am using AutoCAD 2007 P&ID Demo and am having problems printing the
lineweight. It is just too big. Is it just me?

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD P&ID Category!

The AutoCAD P&ID forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community