AutoCAD P&ID General

Reply
Valued Contributor
Posts: 83
Registered: ‎03-26-2007
Message 1 of 3 (140 Views)

Information disappears

140 Views, 2 Replies
02-19-2008 08:30 AM
I added an vessel info tag to the driers i created. I added the information (width and height, pressure and temperature) to the tag block. When i close the drawing and re-open it, the information disappears. I am confused?

Eric
*Jorge Lopez
Message 2 of 3 (140 Views)

Re: Information disappears

02-19-2008 12:24 PM in reply to: hinde
Hi Eric,

Can you provide the steps you followed? I am particularly interested in what
you mean by "added information to the tag block." Do you mean the Tag Assign
dialog that fills properties in the corresponding row shown in the Data
Manager?

Thanks,

Jorge

"Hinde" wrote in message news:5852093@discussion.autodesk.com...
I added an vessel info tag to the driers i created. I added the information
(width and height, pressure and temperature) to the tag block. When i close
the drawing and re-open it, the information disappears. I am confused?

Eric
Valued Contributor
Posts: 83
Registered: ‎03-26-2007
Message 3 of 3 (140 Views)

Re: Information disappears

02-21-2008 08:25 AM in reply to: hinde
I created two blocks to become driers. The driers did not have their own information tag so i copied the Vessel InfoTag_block to use as the Drier Information_block. I inserted the needed information into the drawing for the two driers. Everything looked good but when i close out and re-open the drawing the information for the two driers disappears.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD P&ID Category!

The AutoCAD P&ID forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community