AutoCAD P&ID General Discussion

Reply
ukf
Active Member
ukf
Posts: 9
Registered: ‎05-18-2004
Message 1 of 1 (180 Views)

Substitution grip

180 Views, 0 Replies
11-26-2007 05:35 AM
Hi
When using the P&ID ISO standard the “Substitution grip” palette on a nozzle is not shown then picking the grip.
If I do the same using the P&ID PIP standard, it is possible to change the nozzle type!
Where is the trick for setting this up?

Best regards
Ulla Frederiksen

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD P&ID Category!

The AutoCAD P&ID forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community