AutoCAD P&ID General Discussion

Reply
New Member
wright42
Posts: 1
Registered: ‎10-01-2012
Message 1 of 2 (422 Views)

Off Page Connectors??

422 Views, 1 Replies
10-01-2012 08:06 AM

I figured this would be something very simple, but apparently I'm missing something here, and am looking for a little better explanation than what's given in the "Help". I've followed those instructions step for step, and still puts the connector in the wrong orientation ie...("From" in place of "To" and vice versa). Is there a way either through properties or the data/project manager to specify "From" & "To" or a way to rotate the connectors so that the flow directions match?

 

Also, is there a training book/manual/etc...that I can buy to learn a more indepth version than the "getting started" manual?

Active Contributor
M!chelle
Posts: 39
Registered: ‎09-04-2012
Message 2 of 2 (381 Views)

Re: Off Page Connectors??

10-04-2012 10:46 AM in reply to: wright42

The connectors should be set up to match your line flow.  Have you tried checking your line direction?  If you do SLEDIT there is a reverse prompt that will highlight your line flow arrows inside the command to make sure they are going the correct direction.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD P&ID Category!

The AutoCAD P&ID forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community