AutoCAD P&ID General Discussion

Reply
Contributor
b060106143
Posts: 16
Registered: ‎04-29-2012
Message 1 of 2 (231 Views)

Duct in P&ID

231 Views, 1 Replies
05-14-2013 07:53 AM

Hi everyone

I would like to create Duct lines in P&ID,I can find a option about it in Autocad Plant 3d...is there any way of this. In the same way I also would like creat duct in Plant 3D...Can you help me....

Employee
TomislavGolubovic
Posts: 535
Registered: ‎12-01-2010
Message 2 of 2 (209 Views)

Re: Duct in P&ID

05-14-2013 05:17 PM in reply to: b060106143

How do you want it listed in the bill of materials, as a line, as a piece of equipment? If its a piece of equipment, then just add a new class to the equipment class, or if you want to just show it as a line, then add a new line to the pipe lines class, under the P&ID DWG settings.



Tomislav Golubovic
Plant Solutions Engineer
Autodesk Australia / New Zealand
Autodesk, Inc.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

New AutoCAD P&ID Category!

The AutoCAD P&ID forum has moved into it's very own category page, and can no longer be found within the Additional Product Forums.

Ask the Community