AutoCAD Mechanical General Discussion

Active Member
Posts: 7
Registered: ‎06-25-2014
Message 1 of 2 (72 Views)

Creating Drawings using Inventor Model

72 Views, 1 Replies
06-25-2014 09:04 AM

Is it possible to create an AutoCAD Mechanical drawing using an Inventor Assembly file as the base view but be able to use a different Positional Representation other than Master?

Posts: 3
Registered: ‎07-24-2013
Message 2 of 2 (50 Views)

Re: Creating Drawings using Inventor Model

06-29-2014 07:52 PM in reply to: maschilke20

Yes you can. You can select the positional representation from the Representation panel, from the Drawing View Creation ribbon contextual tab at the time you generate the base view (VIEWBASE COmmand). Check this link out.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community