AutoCAD Map 3D General

Reply
Active Contributor
Posts: 41
Registered: ‎03-25-2008
Message 1 of 2 (197 Views)

viewport is blank when creating a raster image

197 Views, 1 Replies
06-29-2012 11:10 AM

I am using MAP3D 2013 and trying to create a raster image file for use in anther document (the document will not accept a dwg or dwf file, only a raster image).

When I use the JPGOUT (or PNGOUT or BMPOUT or TIFOUT) command I can select all of the objects and viewport; there is no problem creating the file.  But when I open up the raster image, only the viewport outline and objects in paperspace have come accross; the viewport appears empty. 

 

In MAP, the viewport is turned on and I can see everything as intended.

 

Any suggestions?

Alicia
*Expert Elite*
antoniovinci
Posts: 1,492
Registered: ‎06-03-2011
Message 2 of 2 (187 Views)

Re: viewport is blank when creating a raster image

06-30-2012 04:39 AM in reply to: amm30165

1] _PLOTTERMANAGER

2] add the TIFF UNCOMPRESSED device

3] plot to file by means of that virtual printer

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community