AutoCAD Map 3D General

Reply
Active Contributor
BigDumbWeirdo
Posts: 46
Registered: ‎04-15-2011
Message 1 of 1 (77 Views)

command line entry error

77 Views, 0 Replies
04-12-2013 01:04 PM

I'm having a recurring problem with ACAD Map 2009. Occasionally, with no other indication, typing in one command on the command line will result in another command being executed. There doesn't seem to be any rhyme or reason to it, beyond the fact that the substituted command is usually either ERASE or INSERT. I've included a screencap showing the most recent occurence. I've also seen it substitute the rotate, move, copy and scale commands. I haven't been able to figure out any possible causes. I use a rather large (140k) customized LISP file, but others in my office do not, and they also experience this problem. I've tried disabling it, with no luck as well. I've also tried googling it, and only found one instance of someone describing the same problem, and only one response, which was to check the dynamic input settings. However, I do not use dynamic input (I like to rock it old skool :smileyvery-happy:), and haven't found any options that might correspond to this issue regardless. Any help would be appreciated.

MESSUP.JPG

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community