AutoCAD Map 3D General Discussion

Active Contributor
Posts: 46
Registered: ‎04-15-2011
Message 1 of 1 (173 Views)

Strange lineweight effects in certain arcs using certain linetypes.

173 Views, 0 Replies
10-08-2012 11:49 AM

I'm getting this strange effect whenever I use the linetype shown. As you can see, the global width of the polyline is set. Anyone have any ideas as to why? Couple of things I've noticed:

Only this linetype seems to do it (this is the only linetype with a symbol in it, specifically, '%%c').

I also noticed elsewhere, where there's a smaller arc on a line with the same linetype, there was what looked like a branch of the polyline shooting off to one side, although it had not vertices.



You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community