AutoCAD Map 3D General

Reply
New Member
Posts: 2
Registered: ‎07-23-2012
Message 1 of 3 (195 Views)

Lat and long

195 Views, 2 Replies
08-07-2012 07:09 AM

So i have a set up prepared of 0degrees 0 minutes E TO 12 degrees E then 0 degrees north to 12 degrees north, how do i input coordinates so i can have an exact position od 3degrees 14 minues E 6 degrees 45 minutes N? massively need help here!!

*Expert Elite*
antoniovinci
Posts: 1,498
Registered: ‎06-03-2011
Message 2 of 3 (168 Views)

Re: Lat and long

08-08-2012 10:55 PM in reply to: alexandra.thomson

Whoa, madame, ain't gotcha...

Please write all again, as you should explain it to your grandmother, slooowly and eaaasy.

Valued Mentor
Posts: 376
Registered: ‎03-24-2004
Message 3 of 3 (160 Views)

Re: Lat and long

08-09-2012 02:43 AM in reply to: antoniovinci

try this format after you start the line

 

@distance<n45d45'45"E

 

 

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you interested in helping shape the Autodesk Community?
We’re looking at a few different ways to improve the “All Forums” landing page and need your feedback! If interested, please take a few minutes to fill out the following Usability Study. Thank you for your time!

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community