AutoCAD Map 3D General Discussion

Reply
Active Contributor
deetersmith
Posts: 41
Registered: ‎09-18-2007
Message 1 of 3 (267 Views)

Gas line sliding mile classification

267 Views, 2 Replies
05-29-2012 06:17 AM

Is anyone else working on gas transmission classification using the "sliding mile" for the building count?  If so what procedure are you using.  At this point I have run the 660' buffer around the lines added the address/structure point queried to within the buffer polygon then select all the points along a mile of point to get a count.  Tedious but working so far.  I just wonder if there is a better way.

 

Valued Mentor
parkr4st
Posts: 418
Registered: ‎03-24-2004
Message 2 of 3 (264 Views)

Re: Gas line sliding mile classification

05-29-2012 06:52 AM in reply to: deetersmith

it showed up earlier here

 

http://forums.autodesk.com/t5/AutoCAD-Map-3D/Challenge-to-any-Lisp-guru-to-help-me-beat-my-ESRI-Co-w...

 

Don't know if any conclusion was reached

 

Dave

Active Contributor
deetersmith
Posts: 41
Registered: ‎09-18-2007
Message 3 of 3 (243 Views)

Re: Gas line sliding mile classification

05-30-2012 01:29 PM in reply to: parkr4st

I can not find that there was a decision made.  If there is anyone willing to help with this it would be greatly appreciated.  I know I am not the only person dealing with the situation.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community