AutoCAD Map 3D General

Valued Contributor
Posts: 66
Registered: ‎01-22-2010
Message 1 of 5 (1,029 Views)
Accepted Solution

Curve solver

1029 Views, 4 Replies
12-17-2010 01:03 PM

I was recently using Civil 3D 2010, but am now using Map 2007, ( and this was a promotion?). I am looking for a "Curve Solver", and saw in the discussion groups that one was made by Peter Funk, and even improved upon by Laurie Comerford. I cannot find either one, and wodered if anyone knew exactly where to find them. They mention that it can be downloaded, but I cannot find the areas they refer to. If someone could, it would be helpful to post a direct link to the web page either program is found on.

Distinguished Contributor
Posts: 127
Registered: ‎11-13-2006
Message 2 of 5 (957 Views)

Re: Curve solver

01-06-2011 12:47 PM in reply to: tommcgtx

Do the attached lisp programs do what you are looking for?

Valued Contributor
Posts: 66
Registered: ‎01-22-2010
Message 3 of 5 (800 Views)

Re: Curve solver

04-28-2011 03:34 PM in reply to: cjneper

Yes, that work's! I noticed that you can only input angles in decimal for (instead of DDMMSS). That's ok, but it would be nice to be able to input Degrees, Minutes, Seconds.

Posts: 14
Registered: ‎07-20-2007
Message 4 of 5 (512 Views)

Re: Curve solver

03-22-2013 08:09 AM in reply to: cjneper

How do you run it?

*Expert Elite*
Posts: 1,576
Registered: ‎06-03-2011
Message 5 of 5 (499 Views)

Re: Curve solver

03-23-2013 10:45 AM in reply to: ginopalomo

Command: _APPLOAD

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Are you familiar with the Autodesk Expert Elites? The Expert Elite program is made up of customers that help other customers by sharing knowledge and exemplifying an engaging style of collaboration. To learn more, please visit our Expert Elite website.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community