AutoCAD MEP
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
*scott
mvpart water heater
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
74 Views, 0 Replies
08-03-2003 11:18 PM
I have inserted a water heater from the plumbing mvparts catalog. When I use
the compass and select the 90 degree angle only one line is shown down the
middle of the water heater. The top and bottom lines are shown. Is their a
fix for this?
Scott
RGD
the compass and select the 90 degree angle only one line is shown down the
middle of the water heater. The top and bottom lines are shown. Is their a
fix for this?
Scott
RGD
