AutoCAD MEP
Reply
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic to the Top
- Bookmark
- Subscribe
- Printer Friendly Page
Is everyone creating hubless pipe?
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
111 Views, 1 Replies
07-28-2003 04:18 AM
I have yet to find anything on hubless pipe, or anyone to respond to prior questions in regards to hubless pipe. If anyone has thoughts on quick and dirty (or clean) ways to get some hubless pipe into my drawings... i'm all ears... or I guess eyes since this is all written and read, not spoken and heard... but you know what I mean. -- I've looked through other pipe catalogs and they are all less than exactly what i need to at least make it look accurate... and I was hoping to finish this up quickly as I'm moving on to greener pastures.
*P.Temporale
Re: Is everyone creating hubless pipe?
Options
- Mark as New
- Bookmark
- Subscribe
- Subscribe to RSS Feed
- Highlight
- Email to a Friend
- Report Inappropriate Content
07-29-2003 08:46 PM in reply to:
bil-with-one-L
Bil I have a set of no hub fittings I created as MV
Blocks. for pipe I use the #40 butweld, the I insert each fitting as a MV
block. It is a pain in the a!!, but (as the wizards at Autodesk must be
getting paid under the table by the plastic pipe industry) it's the best that I
could come up with. If their was a location I could post them I
would. If you want them just e-mail me.
Blocks. for pipe I use the #40 butweld, the I insert each fitting as a MV
block. It is a pain in the a!!, but (as the wizards at Autodesk must be
getting paid under the table by the plastic pipe industry) it's the best that I
could come up with. If their was a location I could post them I
would. If you want them just e-mail me.
"bil-with-one-L" <
href="mailto:cad1@mclaughlin-mechanica.com">cad1@m
wrote in message
href="news:f17b998.-1@WebX.maYIadrTaRb">news:f17b9
href="mailto:cad1@mclaughlin-mechanica.com">cad1@m
wrote in message
href="news:f17b998.-1@WebX.maYIadrTaRb">news:f17b9
style="PADDING-RIGHT: 0px; PADDING-LEFT: 5px; MARGIN-LEFT: 5px; BORDER-LEFT: #000000 2px solid; MARGIN-RIGHT: 0px">I
have yet to find anything on hubless pipe, or anyone to respond to prior
questions in regards to hubless pipe. If anyone has thoughts on quick and
dirty (or clean) ways to get some hubless pipe into my drawings... i'm all
ears... or I guess eyes since this is all written and read, not spoken and
heard... but you know what I mean. -- I've looked through other pipe catalogs
and they are all less than exactly what i need to at least make it look
accurate... and I was hoping to finish this up quickly as I'm moving on to
greener pastures.
