AutoCAD MEP Wishes

Reply
Active Contributor
Posts: 27
Registered: ‎06-15-2007
Message 1 of 1 (165 Views)

Eccentric Reducers for piping not correct

165 Views, 0 Replies
05-05-2009 12:42 PM
When drawing eccentric reducers in piping they do not come in properly, you have to rotate them 45 deg. so that they are flat on top. the offset dimension also does not appear to be correct.

You are not logged in.

Log into access your profile, ask and answer questions, share ideas and more. Haven't signed up yet? Register

Announcements
Welcome to the new Autodesk Community!
If this is your first visit, click here to get started and make the most of the Community. Let us know what you think of the new experience in the Community Feedback Forum.

Need installation help?

Start with some of our most frequented solutions to get help installing your software.

Ask the Community